Most important characteristics of the Maxtec UltraMaxO2:

• 3-in-1: measures oxygen purity (in %), delivered volume/flow (in LPM) and outlet pressure (in PSI or kPa)
• Integrated ultrasonic oxygen sensor doesn’t need to be replaced or calibrated
• The inlet port is better protected against external influences
• LCD screen with clear display of the results
• Compact and lightweight

For whom is the Maxtec UltraMaxO2 suitable?

For anyone who wants to check 3 essential parameters of an oxygen concentrator: oxygen purity, delivered volume (flow) and outlet pressure.

For anyone who wants to check 3 essential parameters of an oxygen concentrator: oxygen purity, delivered volume (flow) and outlet pressure.

The UltraMaxO2 is intended for use with an oxygen concentrator. The device is especially useful in nursing homes, hospitals and respiratory equipment repair centres for respiratory equipment. With the device, you can measure the oxygen purity, the delivered volume (the flow) and the outlet pressure of the concentrator. Thanks to the ultrasonic technology, calibration is not necessary, which will save you time.

Practical design and easy to use

The UltraMaxO2 is lightweight and handheld. The silicone case protects the device against external influences. The oxygen tubing inlet port is placed inside a notch for better protection. The device is equipped with an integrated ultrasonic oxygen sensor, so you don’t have to replace oxygen sensors over time. While using the device, the results are clearly displayed on the LCD screen. The UltraMaxO2 works on 2 AA batteries, which are included as standard.

Checking the oxygen purity and volume (flow)

Would you like to measure the oxygen purity and the delivered volume of the oxygen concentrator? Then connect one end of the supplied connection tubing to the inlet port of the UltraMaxO2. Connect the other end of the tubing to the oxygen outlet of the concentrator. The oxygen purity in % and the volume (flow) in liters per minute will appear on the screen. Both values are displayed in tenths.

Tip: Is there still a humidifier attached to the concentrator? Then remove it before using the UltraMaxO2.

Checking the outlet pressure

In order to measure the concentrator outlet pressure, place your finger on the outlet port of the UltraMaxO2 (on the side of the device). The outlet pressure is displayed in tenths: in PSI (Pounds per square inch) or in kPa (kilopascals). The device itself has a button inside that allows you to change from PSI to kPa and vice versa.

What’s included:

• Maxtec UltraMaxO2 device
• Silicone case
• 2 AA batteries
• Connection tubing
• Manual